Power Distribution

 

 The PDU is a unit that replaces your unreliable circuit breakers and relays in your race car , The PDU inputs and outputs are fully programable and have a trip out function to turn on back up systems ,The PDU also sends data to any Motec dash using Danzio CAN template .These units are becoming a standard in new race cars and are installed on many winning cars already.                                                                                                                                                              

PDU SoftWare Example 

Life Racing PDU32 Power Controller.

 

General Microprocessor controlled power switching, monitoring and fusing unit Fully calibratable input to output schematic mapping with latch, flash, and logic functions.

 

Fully configurable inrush current, high current and low current trips Control and diagnostic communication with ecus, datalogging or telemetry equipment.

 

Outputs 32 switched power outputs with individual trip configuration.

 

Current monitoring on all outputs available on datastream or pc.

 

Maximum current per output 30A continuous, 45A for short periods.

 

Inputs 32 logic inputs with configurable pull up/down, active low/high, validation time and debounce time.

 

4 Voltage level inputs with configurable switching set points 32 soft inputs via CAN with configurable validation time and debounce time.

 

Temperature Internal temperature monitoring Fault Pin Single pin fault indicator lamp output and reset input.

 

Interfaces Ethernet for pc configuration and monitoring connection CAN 2.0B interface for communication with other controllers or logging systems RS232 serial interface for communication with other controllers or logging systems.

 

Power Supply 5 to 26.5V or 10 to 32V input voltage range.

 

Physical 4 Deutsch Autosport or MIL connectors.

 

CNC machined, ‘O’ ring sealed, anodised aluminium case.

 

Maximum dimensions 208 x 120 x 30 mm (plus connectors) Total mass 885 grams.